EPS Sandwich Panel House

T –type EPS Sandwich Panel house is called luxury activity prefab house, T-type prefab house is usually used to do the site project Department office, the manager's dormitory, T room generally uses 1150 board for the unit, 1T is equal to 1150, the board length 1150mm high 1000mm, from the appearance, T room is not see the Movement Room column, the appearance is generous and beautiful

1. The roof structure is triangular truss and the roof purlin is 40mm*80mm square tube.
2. The floor structure is parallel girder, beam height is 300mm, floor girder height is 380mm, grate bar is C40mm*80mm*15mm
3. Both ends of the main truss of the truss and floor are linked with the steel post through screw connection pieces.
4. The foundation of 300mm*300mm Bar Foundation, speaking on behalf of the C20.
5. There are parallel beams under the columns and there are C-shaped steel connection supports. The external wall panels are fixed to increase its wind stability.

Engineer Office
 

Engineer Living

Engineer Laboratory

The Roof Dead load 0.15KN/M²
Dynamic Load 0.50KN/M²
Floor Dead load 0.20KN/M²
Dynamic Load 2.00KN/M²
Wind load 0.60KN/M²

1. The Structure Type: light steel frame structure, 2 stories above ground.
2. Seismic fortification intensity of this project: 7 degrees; design seismic grouping: first group: design basic earthquake acceleration value: 0.15g.
3. The standard of seismic fortification of this engineering building: Class B.
4. Design service life: 10 years. 

1. Measure the size, and put the ground beam by expansion screw.

2. Lay the foundations, and Install the column and herringbone beam.

3. Install the wall panel.

4. Install the roof panel.

5. Istall the door and window. Seal the eaves and connection parts between wall panel and roof panel.

6. Finish the installation.

We provide enough installation accessories for each house, like expansion screw, flat screw, self-dilling screw, rivet, glue, groove,etc.